Sludge Dewatering With Our ASP System
A Simple and Economic Alternative To Existing Dewatering Systems.
Our ASP (Automatic Sludge-dewatering Press) offers a simple and economic alternative to existing dewatering systems for small to medium capacity water and wastewater treatment plants.
Unlike traditional systems, the ASP has few moving parts and consumes very little energy. Moreover, this innovative and well- proven dewatering solution employs a fully automated batch-treatment approach, requiring little human intervention.
Working together with our clients, Gurney Environmental are able to deliver the benefits of decades of experience in the design and construction of wastewater treatment plants.
ASP Offers Strong Benefits
- Skid-Mounted or Containerised
- Cost Effective (both CAPEX and OPEX)
- Simple to Operate and Maintain
- Robust Stainless Steel Construction
- Flexible (permanent or mobile) Operation
- Environmentally Friendly
HOW IT WORKS
The ASP press works on a batch principle, controlled by a sophisticated on-board controller. The controller allows the operator to readily change parameters in order to optimise the press operation, increase throughput or alter the output dryness, depending on the specific sludge being dewatered.
- Sludge is pumped into the mechanical flocculator where it mixes with flocculent. The flocculated sludge enters the space between the screen and the internal membrane with the excess filtrate percolated through the screen slots, while the thickened sludge (about 10% DS) is retained. The semi-dry sludge accumulates at the bottom of the cylindrical screen and settles upward.
- When the screen is full, a sensor signal stops the filling/thickening sequence and the pressing sequence starts. The internal flexible membrane is inflated, pushing the solids against the screen surface with a radial force, which is the fastest and most efficient way to dewater sludges. This step is time controlled for a few minutes with both pressing and pulse-pressing steps controlled by the PLC program. The excess fluid is drained out externally.
- At the end of the pressing sequence, the lower door membrane deflates and the door retracts. The scraper carriage is then activated, cycling up and down the internal surface of the wedge screen dislodging the sludge cake, thereby allowing it to fall freely into a skip or onto a conveyer.
- After the scraping sequence has been completed, the screen is automatically backwashed by a ring of spray heads moving up and down the outside surface forcing any remaining sludge caught in the screen back through the screen. Once complete, a new filing sequence is started automatically. Once in operation, the press will dewater the sludge until there is not enough sludge, at which point the press will remain in “Stand By” mode until re-activated. The PLC program includes a diagnostic feature that will prevent any faulty operation and allows the operator to fix the problems easily and safely. If there is a problem within the cycle, the press will cease operation and automatically give an alarm.
The ASP press addresses the ever increasing problem of dealing with sludges from water and wastewater treatment plants and the resultant financial and legistlative implications associated with transportation and disposal of these sludges. The ASP is very versitile and ideally suited for use in the following applications: